Procedure :
- Cisco CatOS Configuration
- Go to Enable mode
- Create Trunk
- cswitch> set trunk {port to trunk on} on dot1q {vlans to allow}
- EXAMPLE: set trunk 6/5 on dot1q 2-3,10,20,30,69,96,99
- This example sets port 6/5 to the 802.1q standard, and only allows VLANs 2-3,10,20,30,69,96, and 99 to go across it.
- Cisco IOS Configuration
- Go to Enable mode
- Go to Config Mode
- iosswitch> config terminal
- Go to Interface of the Trunk
(i.e. GigabitEthernet 0/1)
- iosswitch> interface GigabitEthernet0/1
- Create the trunk on the interface
- iosswitch> switchport trunk encapsulation dot1q
- iosswitch> switchport mode trunk
- Save the configuration
- iosswitch> end
- iosswitch> write mem
|